To use manual dial with the flatbed scanner
Only the HP LaserJet 3030 all-in-one and the HP LaserJet 3380 all-in-one have a flatbed
. The control panel display shows the following message: Send from
glass? 1=Yes 2=No.
to select YES. The control panel display shows the following message: Load
page:X Press [enter], where X is the page number.
3. Scan a page into memory by placing the sheet print-side-down on the flatbed scanner
. After scanning the page, the device control panel display
shows the following message: Another page? 1=Yes 2=No.
4. Complete one of the following steps:
If you have more pages to scan, press
to select YES, and then repeat step 3 for each
page of the fax job.
If you are finished, press
to select NO, and then go to the next step.
5. When finished scanning all pages into memory, begin dialing. The device dials the
number as you press each digit. This allows you to wait for pauses, dial tones,
international access tones, or calling card acceptance tones before continuing to dial.
Using manual dial